SERIES 60 SERVICE MANUAL 5. Inspect inside diameter of cylinder liners. [a] Set the cylinder bore gage on zero in master setting fixture. Use cylinder bore gage (J–5347–B) to measure the inside diameter of the liner of various points. The maximum diameter of a used liner is 130.100 mm (5.122 in.) for 12.7 and 11.1 L and 133.100 mm (5.240 in.) for 14L at any measurement location. See Figure 1-336. Also check the liner for taper and out-of-round. Figure 1-336 Cylinder Liner Measurement Diagram [b] If the taper and out-of-round exceed 0.025 mm (0.001 in.), replace with a new part. 6. Inspect the cylinder liner. [a] Check the seal ring and crevice seal grooves for burrs or sharp edges.
[b] If any are detected, smooth with an emery cloth. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-369