1.23 CYLINDER LINER [a] Check the liner flange for cracks, smoothness and flatness on both the top and bottom surfaces. [b] If these are detected, replace with a new part. 4. Inspect the block bore and cylinder liner. [a] Measure the block bore and the outside diameter of the liner. The liner specifications are listed in Table 1-17. The block specifications are listed in Table 1-16. Refer to section 1.1.3.3 for procedures. [b] If the liner does not meet specification, replace with a new part. (Rev. 2005) All information subject to change without notice. 1-368 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION