SERIES 60 SERVICE MANUAL 1. Inspect the cylinder liner. [a] Check the cylinder liner for cracks or scoring. [b] If any of these are detected, replace with a new part. NOTICE: Erosion is due to poor cooling system maintenance. If uncorrected, it will eventually make holes through the liner. This can result in combustion gases blowing water out of the radiator, oil in the coolant, or when the engine is stopped will allow water to flow into the cylinder and result in major engine damage due to water in the oil or hydraulic lockup. [c] Check the cylinder liner for cavitation erosion. See Figure 1-335. 1. Cracks 3. Erosion 2.
Cylinder Liner Figure 1-335 Cylinder Liner Cavitation Erosion [d] If cavitation erosion occurs, replace with a new part. Refer to section 1.23.3. NOTICE: Series 60 cylinder liners are honed at the factory with a process that cannot be duplicated in the field. For this reason, honing of used liners should not be attempted. 2. Inspect the outside diameter of the liner. [a] Check liner for fretting. [b] If any fretting is found, remove it from the surface of the liner with a coarse, flat stone. 3. Inspect the liner flange. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-367