Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.23 CYLINDER LINER NOTE: After removing liners from an engine and prior to installing liners, always store them in an upright position until ready for use. Liners left on their side for any length of time can become egg-shaped and distorted, making installation in cylinder bores difficult or impossible. If the cylinder liners are to be reused, they should be marked for cylinder location and engine orientation, a paint mark can be used to indicate the front of engine so they may be installed to the same cylinder from which they were removed. [c] Remove the tool from the liner. [d] Remove the seals (all three) from the liner and discard them.

1.23.2.1 Cleaning of the Cylinder Liner Clean the cylinder liner prior to inspection as follows: 1. If cleaning a new or used liner, wash the liner with a strong detergent and warm water solution, scrubbing with a non-metallic bristle brush. 2. Rinse with hot water or steam. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 3. Dry the liner with compressed air. NOTICE: If the liners are not to be installed at this time, oil them lightly with clean engine lubricating oil and store them upright in a clean, dry area.

Do not allow the liners to rest on their sides and do not store anything on top of the liners. 4. Coat the bore of the liner with clean engine lubricating oil. 5. Allow the liner to sit for 10 minutes (to allow the oil to work into the surface finish). 6. Wipe the inside of the liner with clean, white paper towels. 7. If a dark residue appears on the towels, repeat the oiling and wiping procedure until residue no longer appears. 1.23.2.2 Inspection of Cylinder Liner Inspect the cylinder liner as follows: (Rev. 2005) All information subject to change without notice. 1-366 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION