Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 5. Install J–35597–A, over the liner to be installed. See Figure 1-337. NOTE: It is necessary to leave the cylinder liner installation tool in place until after the liner protrusion is measured. Figure 1-337 Cylinder Liner Installation Tools 6. Thread three cylinder head bolts through the tool and into a head bolt hole, so that the round shoe of the tool is centered over the liner. 7. Tighten the bolts. NOTE: It is not necessary to torque the bolts. 8. Turn the threaded center bolt in a clockwise direction. As the round shoe of the tool reaches the liner, ensure that the shoe is properly positioned into the cylinder liner. 9.

Continue turning the bolt until the liner bottoms in the cylinder counterbore. Apply a tightening torque of 60 N·m (44 lb·ft) to the installation tool center bolt. 10. Install a dial indicator sled gage. See Figure 1-318. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-371