SERIES 60 SERVICE MANUAL 1.24.2 Gear Train and Engine Timing Check Procedure When an engine is out of time, the camshaft timing can be checked by following the camshaft timing check procedure. Refer to section 1.28.6.1. If the engine is out of time, a visual inspection of the gear train is required. Refer to section 1.10.2 and perform all of the steps under "Removal of Gear Case Cover". For engines equipped with the compact gear trainrefer to section 1.11.2 and perform all the steps under "Removal of Gear Case Cover". 1.24.2.1 Check Engine Timing Gear train noise is usually an indication of excessive gear lash, chipped, pitted or burred gear teeth, or excessive bearing wear.
Therefore, when noise develops in a gear train, the gear case cover should be removed and the gear train and its bearings inspected. A rattling noise usually indicates excessive gear lash. A whining noise indicates too little gear lash. 1. Check engine timing as follows: [a] Examine all timing marks to ensure they are aligned. See Figure 1-341. [b] It may be necessary to remove the gears to align the timing marks. Refer to section 1.33.2. [c] For engines equipped with the compact gear train remove the gears to align the timing marks. Refer to section1.32.2. NOTE: The gear ratio between the adjustable idler gear and the camshaft drive gear causes a "hunting-tooth" situation.
Therefore, the bull gear and rocker arm assemblies should be removed to align the timing marks. See Figure 1-341. [d] If any gears are removed or installed, or if lash between any two gears is out of specification, check the lash between the mating gears. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-381