Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.24 GEAR TRAIN AND ENGINE TIMING 2. Check the crankshaft timing gear-to-oil pump idler gear lash measurement as follows: [a] Fasten a dial indicator and magnetic base to the cylinder block so that the stem of the dial indicator rests on a tooth of the oil pump drive gear. See Figure 1-346. Figure 1-346 Crankshaft Timing Gear-to-Oil Pump Idler Gear Lash Measurement NOTE: The oil pump design changed effective with 1991 model year engines. However, the oil pump gear lash measurement procedure is the same for both style pumps. [b] Hold the crankshaft timing gear stationary, and rotate the oil pump drive gear in one direction, as far as it will go, without moving the crankshaft timing gear.

[c] Zero the dial indicator. [d] Move the oil pump drive gear in the opposite direction, as far as it will go, without moving the crankshaft timing gear. [e] Read and record the total gear lash. NOTE: The gear lash must be checked in four positions 90 degrees apart. NOTE: The lash between the crankshaft timing gear and oil pump drive gear must be measured with the engine in a running position. See Figure 1-346. (Rev. 2005) All information subject to change without notice. 1-382 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION