1.24 GEAR TRAIN AND ENGINE TIMING 8. When measuring or adjusting the gear lash between the adjustable idler gear and the camshaft drive gear, the valve and injector spring pressures must be removed from the camshaft lobes. Use the following procedure for this adjustment: NOTE: The front and rear rocker shafts look identical, but must not be interchanged due to different oil passage patterns. The outboard ends of the rocker arm shafts are marked for identification with the DDC logo. See Figure 1-349. Use care to ensure that the rocker arm shaft assemblies are replaced exactly as removed. Figure 1-349 Rocker Arm Shaft Identification Mark (Rev.
2005) All information subject to change without notice. 1-386 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION