SERIES 60 SERVICE MANUAL [a] Install the gear lash indicator (J–35596–15, part of tool set J–35596–A) into the threaded hole of the camshaft drive gear. See Figure 1-350. Bar the engine over until the tool is at the three o'clock position. 1. Gear Lash Adjustment Tool 4. Dial Indicator 2. Adjustable Idler Gear Retaining Nut 5. Indicator Idler Gear Hole 3. Magnetic Base 6. Adjustable Idler Gear Retaining Nut Figure 1-350 Camshaft Drive Gear-to-Adjustable Idler Gear Lash Measurement NOTE:
Since the teeth of the camshaft drive gear are not accessible with the gear case cover installed, the lash is measured on the pedestal installed in the threaded hole, which is located exactly half-way between the center and edge of the camshaft drive gear. For this reason, the reading obtained will be exactly 1/2 of the actual gear lash. [b] Mount a dial indicator adaptor and dial indicator. See Figure 1-350. [c] Adjust the stem of the dial indicator to rest on the flat of the pedestal. [d] If the adjustable idler gear has been removed, torque the three flanged nuts that retain the adjustable idler gear hub to the gear case to 57-67 N·m (42-49 lb·ft) to seat the assembly before proceeding.
[e] Loosen the three locknuts that retain the adjustable idler gear hub to the gear case until they are hand tight. [f] Insert the dowel portion of the gear lash adjusting tool (J–35596–A) through the hole in the adjustable idler gear retaining plate and into the adjustable idler gear hub, using the bottom two adjustable idler gear cover bolt holes. See Figure 1-350. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-387