Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.24 GEAR TRAIN AND ENGINE TIMING [g] Turn the adjusting screw of the tool in a clockwise direction to force the adjustable idler gear against the camshaft drive gear, until there is zero lash between the two gears. See Figure 1-351. Figure 1-351 Adjustable Idler Gear-to-Camshaft Drive Gear Lash Adjustment [h] Zero the dial indicator. [i] Hold the adjustable idler gear by inserting a screwdriver through the hole provided in the gear case. Engage one of the adjustable idler gear teeth and apply pressure on the screwdriver to move the gear in a counterclockwise direction. This will prevent the gear from moving. [j] Attempt to turn the camshaft drive gear, and watch the dial indicator pointer.

NOTE: If there is zero lash between the two gears, the dial indicator pointer will not move from zero. [k] Turn the adjusting screw of the gear lash adjusting tool (J–35596–A) approximately 1-1/2 turns or until the proper gear lash is obtained. (Rev. 2005) All information subject to change without notice. 1-388 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION