SERIES 60 SERVICE MANUAL [l] When checking gear lash, hold the adjustable idler gear stationary . Refer to step 8[i] as the first step and refer to step 8[j] as the final step, and rotate the camshaft drive gear with your right hand. See Figure 1-352. Figure 1-352 Checking Adjustable Idler Gear-to-Camshaft Drive Gear Lash NOTE: Remember to multiply the reading obtained by two to get the actual lash measurement. The specification of gear lash is 0.051-0.229 mm (0.002 -0.009 in.) with a maximum of 0.305 mm (0.012 in.) for used parts. [m] Check the gear lash with the pedestal at the 3, 6, 9 and 12 o'clock positions, exactly as previously performed.
[n] When the proper readings of 0.025-0.114 mm (0.001-0.005 in.) are obtained at all four (4) positions, hold the idler gear. Refer to step 8[i]as the first step and refer to step 8[j] as the final step, and torque the top two adjustable idler gear flanged nuts to 57-67 N·m (42·49 lb·ft). [o] Check the gear lash again as outlined above, with the flanged nuts torqued, to ensure that gear lash is still within limits. If not correct repeat the procedure. [p] If proper lash measurement cannot be obtained, replace gear(s) with new part(s). Refer to section 1.29.2, refer to section 1.30.2, refer to section 1.34.2and refer to section 1.33.2. [q] Remove the gear lash adjusting tool from the gear case.
[r] Torque the bottom adjustable idler gear flanged nut to 57-67 N·m (42-49 lb·ft) torque. [s] Remove the dial indicator and pedestal from the gear case. [t] Before installing the rocker arm shaft assemblies, check the torque on the end studs to ensure they were not loosened at time of removal. The torque specification is 101-116 N·m (75-86 lb·ft). [u] Install the rocker arm shaft assemblies to the cylinder head. Refer to section 1.3.3. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-389