1.24 GEAR TRAIN AND ENGINE TIMING [v] Adjust the intake and exhaust valve clearances, and fuel injector heights. Refer to section 13.2. [w] Install the valve rocker cover. Refer to section 1.6.8for a one-piece valve rocker cover and refer to section 1.6.9 for two-piece and three-piece rocker covers. [x] Install the camshaft drive gear access cover and the gear case cover. Refer to section 1.10.3. 9. Install the fan support bracket "if required" as follows: [a] Clean the mating surfaces of the fan support bracket and gear case of all old gasket eliminator. Refer to the section on "Gasket Eliminator" in the "General Information" section at the beginning of this manual. [b] Apply a 1/16 in.
bead of Gasket Eliminator PT-7276 (Loctite® 518), or equivalent, to the machined surface of the gear case cover surrounding the adjustable idler gear access. [c] Install the fan support bracket to the gear case cover using the torque values and tightening sequence. See Figure 1-353. Bolt Torque 1-3-5 58-73 N·m (43-54 lb·ft) 2-4 160-200 N·m (118-148 lb·ft) 6 to 10 30-38 N·m (22-28 lb·ft) Figure 1-353 Fan Support Bracket Bolt Torque Sequence (Rev. 2005) All information subject to change without notice. 1-390 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION