Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 10. Check the bull gear-to-accessory drive gear lash measurement as follows: [a] Install the gear lash tool (J–38662) and mount a magnetic dial indicator base and dial indicator to the gear case cover. See Figure 1-354. Figure 1-354 Accessory Drive Gear-to-Bull Gear Lash Measurement [b] Position the dial indicator to read between the scribed lines on the tool. See Figure 1-354. [c] Rotate the accessory drive pulley, read and record the total gear lash. [d] Gear lash measurements are 0.051-0.229 mm (0.002 -0.009 in.) for new parts, and 0.305 mm (0.012 in.) for used parts. [e] If proper lash measurement cannot be obtained, replace gear with a new part.

Refer to section 1.33.2. [f] Remove the dial indicator and gear lash tool. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-391