1.24 GEAR TRAIN AND ENGINE TIMING 11. Check the bull gear-to-water pump drive gear lash measurement for 1991 and later engines (with water pump impeller slip tester (J–35687) as follows: NOTE: The bull gear-to-water pump drive gear lash can be measured using the water pump impeller slip tester (J–35687), refer to step 11[a] through step 11[g]. Or by using the water pump gear lash tool (J–38977–A), refer to step 12. Engines built early in 1991 will need the water pump gear lash checked with the slip tester. These engines do not have a threaded hole in the water pump drive gear retaining bolt to accept the gear lash tool.
EYE INJURY To avoid injury from flying parts when working with components under spring tension, wear adequate eye protection (face shield or safety goggles). [a] Remove the water pump cover snap ring with snap ring pliers. Remove water pump cover and seal ring. [b] Install the water pump impeller slip tester (J–35687), to the water pump impeller with two 5/16-18 bolts, using the instructions supplied with the tool. See Figure 1-355. Figure 1-355 Water Pump Impeller Slip Tester Method (Rev. 2005) All information subject to change without notice. 1-392 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION