1.25 COMPACT GEAR TRAIN AND ENGINE TIMING [a] Install a dial indicator and magnetic base. See Figure 1-366. 1. Bull Gear 3. Crankshaft Gear 2. Dial Indicator Figure 1-366 Crankshaft Timing Gear-To-Bull Gear Lash Measurement [b] Adjust the stem of the dial indicator to rest on the center of a tooth on the bull gear. [c] Preload the bull gear. [d] Zero the dial indicator pointer. [e] Hold the crankshaft timing gear stationary with one hand. Rotate the bull gear and check the total gear lash in four positions of crank gear, approximately 90 degrees apart. [f] Although gear lash for the remaining gear sets is not adjustable, the lash must still be measured.
Lash specifications is 0.051-0.229 mm (0.002-0.009 in.) for new parts and a maximum of 0.305 mm (0.012 in.) for used parts. [g] If lash measurement is exceeded, replace gear with a new part. 4. The procedure for measuring the lash between the bull gear, air compressor and power steering pump drive gear is similar to the steps just mentioned. Refer to step 3 and perform step 3[a], as the first step and refer to step 3[g], as the final step. Gear case cover (Rev. 2005) All information subject to change without notice. 1-408 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION