Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL must be installed to continue on checking the engine timing. Refer to section 1.10.3and perform all of the steps under gear case cover installation. NOTE: Due to the possibility of damaging the crankshaft front oil seal, whenever the gear case cover is removed, the front crankshaft oil seal must be replaced. Replace the crankshaft front oil seal after the gear case cover is installed. Refer to section 1.8.5. 5. The procedure for measuring the lash between the accessory drive gear and air compressor pump drive gear (on vehicle without power steering) is similar to the steps just mentioned.

Refer to step 3 and perform step 3[a], as the first step and refer to step 3[g], as the final step. NOTE: Lash can be measured with the gear case cover installed. Access covers are provided for checking the lash between these gears and the bull gear. 6. The procedure for measuring the lash for the adjustable idler gear is similar to the steps just mentioned. Refer to step 3 and perform step 3[a], as the first step and refer to step 3[g], as the final step. NOTE: These gears are measured with the gear case cover installed. 7. The procedure for measuring the lash between the bull gear and the water pump drive gear is similar to the steps just mentioned.

Refer to step 3 and perform step 3[a], as the first step and refer to step 3[g], as the final step. NOTE: These gears can be measured with the pump installed. 8. Check the bull gear-to-accessory drive gear lash measurement as follows: All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-409