SERIES 60 SERVICE MANUAL 9. Check the bull gear-to-water pump drive gear lash measurement with water pump gear lash tool (J–38977–A) as follows: [a] Remove the pipe plug in the gear case cover. [b] Install the water pump gear lash tool (J–38977–A) through the hole in the gear case and thread it into the special water pump drive gear retaining bolt. See Figure 1-368 . Figure 1-368 Water Pump Gear Lash Tool Method [c] The arm of this tool has an inscribed line. Measuring with a dial indicator at this line of the tool, the gear lash measurement will be an exact 1:1 reading. Gear lash specifications are 0.051-0.229 mm (0.002 -0.009 in.).
[d] If proper lash cannot be obtained, replace the gear with a new part. [e] Remove the dial indicator and the gear lash tool. [f] Install the pipe plug in the gear case cover. Torque to 24-31 N·m (18-23 lb·ft). 10. Check the bull gear-to-air compressor drive gear lash measurement as follows: [a] Mount a magnetic dial indicator base and dial indicator to the gear case cover so that the stem of the dial indicator may be positioned on a tooth of the air compressor drive gear. [b] Preload the drive gear in one direction. [c] Zero the dial indicator. [d] Rotate the air compressor drive gear, read and record the total gear lash.
Gear lash measurements are 0.051-0.229 mm (0.002 -0.009 in.) for new parts, with a maximum of 0.305 mm (0.012 in.) for used gears. [e] If proper lash cannot be obtained, replace the gear with a new part. [f] Remove the dial indicator and magnetic base. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-411