Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.25 COMPACT GEAR TRAIN AND ENGINE TIMING [g] Install the power steering drive coupling to the air compressor drive gear (if equipped with power steering) and insert a new O-ring on the power steering pump (if so equipped). [h] Install the power steering pump to the gear case cover, meshing the drive coupling properly. [i] Install and torque the power steering pump mounting bolts to 30-38 N·m (22-28 lb·ft). Tighten the five bolts alternately and evenly, in a star-shaped pattern, to progressively draw the power steering pump into the gear case cover. NOTE: Do not force the bolts. If resistance is encountered, remove the power steering pump and re-engage the drive hub with the coupling.

[j] If the engine is not equipped with power steering, install the air compressor drive gear access cover using a new gasket. [k] Install and torque the retaining bolts to 30-38 N·m (22-28 lb·ft), using a star-shaped pattern. 1.25.2.2 Engine Timing for the Compact Gear Train Assembly The procedures for measuring and adjusting the gear lash for the compact gear train are as follows: 1. If the camshaft gear assembly has been removed, refer to section 1.26.5 for installation instructions. (Rev. 2005) All information subject to change without notice. 1-412 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION