1.25 COMPACT GEAR TRAIN AND ENGINE TIMING 3. Remove two plugs located on gear case cover. See Figure 1-371. 1. Plug 3. Bull Gear Access Location 2. Idler Gear Access Location Figure 1-371 Idler Gear and Bull Gear Access Holes NOTE: Gear lash measuring tool (J–46303) is magnetized. 4. Install the gear lash measuring tool (J–46303) onto the center of the camshaft drive gear at the three o'clock position. See Figure 1-372. (Rev. 2005) All information subject to change without notice. 1-414 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION