Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 5. Attach the magnetic base on dial indicator to the camshaft gear cover. Adjust the stem of the dial indicator to rest on the flat of measuring tool ( J–46303) at the scribe line on the bar at a 90° angle. Zero the dial indicator. See Figure 1-372. 1. Adjustable Idler Gear Retaining Nut 3. Dial Indicator 2. Magnetic Base Figure 1-372 Compact Gear Train Gear Lash Measurement 6. If the adjustable idler gear has been removed, torque the three nuts that retain the adjustable idler gear hub to the gear case to 57-67 N·m (42-49 lb·ft) to seat the assembly before proceeding. 7.

Loosen the three nuts that retain the adjustable idler gear hub to the gear case until they are hand tight. 8. Insert the dowel portion of the gear lash adjusting tool (J–35596–A) through the hole in the adjustable idler gear retaining plate and into the adjustable idler gear hub, using the bottom two adjustable idler gear cover bolt holes. See Figure 1-372. NOTE: Ensure screwdriver is inserted between camshaft and idler gear teeth and not on the perimeter of the gear, incorrect insertion of the screwdriver will result in incorrect lash measurement readings. NOTE: Do not apply side load with the screwdriver; prying the gears will result in incorrect lash measurement readings.

All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-415