1.25 COMPACT GEAR TRAIN AND ENGINE TIMING 9. Insert a screwdriver through the idler gear access hole provided in the gear case cover. Engage the screwdriver between two of the idler gear teeth and apply pressure on the screwdriver to secure the gear. This will prevent the gear from moving. See Figure 1-373. Figure 1-373 Compact Gear Train Lash Adjustment 10. Zero the dial indicator. 11. Using a rag to protect against the sharp edges of the camshaft, rotate the camshaft by hand and observe the dial indicator pointer. NOTE: Turn the adjuster on tool J–35596–A clockwise to decrease gear lash and counterclockwise to increase gear lash. 12.
Secure the adjustable idler gear with a screwdriver; refer to step 9. 13. Turn the adjusting screw of the gear lash adjusting tool (J–35596–A), approximately 1-1/2 turns. Gear lash should be 0.051-0.229 mm (0.002-0.009 in.). Repeat steps 11 and 12 until proper lash is obtained. NOTE: If there is zero lash between the two gears, the dial indicator pointer will not move from zero. NOTE: Torque idler gear nuts first to prevent any gear movement which would change gear lash settings. (Rev. 2005) All information subject to change without notice. 1-416 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION