SERIES 60 SERVICE MANUAL 14. When the proper readings of 0.051-0.229 mm (0.002-0.009 in.) are obtained at all four positions, secure the idler gear and torque the three adjustable idler gear nuts to 103-113 N·m (76-83 lb·ft.). 15. Check the gear lash with the measuring tool (J–46303) at 3, 6, 9, and 12 o'clock positions. 16. Remove the gear lash adjusting tool (J–35596–A), measuring tool (J–46303) and the dial indicator. 17. If proper lash measurement cannot be obtained, replace gear(s) with new part(s). 18. Before installing the rocker arm shaft assemblies, check the torque on the end studs to ensure they were not loosened at the time of removal.
The torque specification is 101-116 N·m (75 -86 lb·ft). 19. Install the rocker arm shaft assemblies to the cylinder head. Refer to section 1.3.3. 20. Adjust the intake and exhaust valve clearances, and fuel injector heights. Refer to section 13.2. 21. Install the valve rocker cover. Refer to section 1.6.8 for a one-piece valve rocker cover and refer to section1.6.9 for two-piece and three-piece rocker covers. 22. Install the camshaft drive gear access cover. Torque the five bolts to 30-38 N·m (22-28 lb·ft) and install the two plugs into the gear case cover and torque the plugs to 38-42 N·m (28-31 lb·ft).
1.25.3 Installation of Removed Compact Gear Train Components After all of the gear lash measurements have been taken, assemble the engine components as follows: 1. Install the air conditioner compressor and brackets (if so equipped). Install the air conditioner drive belt. 2. Install the alternator and brackets. Refer to section 9.2.3. 3. Install the alternator drive belts. Refer to section 14.6.9. 4. Install the fan and fan hub assembly. Refer to section 4.6.6. 5. Adjust the alternator, fan and air conditioner compressor drive belts to specifications. Refer to section 14.6.9. Torque the accessory mounting bolts to specifications. 6.
Install any other equipment such as hoses, brackets, lines or electrical looms that were removed to gain access to the engine gear case cover. 7. Install the engine oil pan. Refer to section 3.11.4. 8. Fill the engine crankcase. Refer to section 14.6.1. 9. Refer to section 12.7for verification of proper gear train and engine timing. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-417