SERIES 60 SERVICE MANUAL 1. Install the crankshaft timing pin (J–45947) into bracket and rotate the engine over by hand until the timing pin drops into the locating hole in the crankshaft, the engine is now at TDC on cylinder No.1. See Figure 1-381. 1. Timing Pin Figure 1-381 Crankshaft Timing Pin 2. Remove the valve rocker cover. Refer to section 1.6.2 (one-piece), section 1.6.3 (two-piece), and section 1.6.5 (three-piece). 3. Remove Jake Brake® assemblies refer to section 1.36. 4. Remove the five bolts for the camshaft gear cover inspection plate and remove the plate. See Figure 1-382. 1. Bolt 3. Gasket 2.
Cover Figure 1-382 Gear Case Assembly Cover All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-425