1.26 CAMSHAFT GEAR ASSEMBLY SERIES 60 EXHAUST GAS RECIRCULATION (EGR) MODEL 5. Remove Synchronous Reference Sensor/Crankshaft Position Sensor (SRS/CMP). 6. Verify camshaft timing as follows: [a] Look at the timing hole in the camshaft gear. [b] The timing hole should be aligned with the timing hole in the back of the gear cover, located at the 5 o'clock position. See Figure 1-383. [c] If the timing holes are not aligned correctly remove the crankshaft timing pin and rotate the engine one more complete revolution . When the timing pin drops back into the hole in the crankshaft check the timing of the camshaft. Refer to steps 6[a] and 6[b]. 1. Camshaft Gear Cover 2.
Timing Hole Figure 1-383 Timing Verification (Rev. 2005) All information subject to change without notice. 1-426 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION