Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 6. If the camshaft is scored, inspect the camshaft follower rollers. 7. Replace damaged camshaft followers. 8. If there is a doubt as to the acceptability of the camshaft for further service, determine the extent of camshaft lobe wear as follows: NOTE: The camshaft can be in or out of the engine during this procedure. [a] Using a feeler gage, 0.038-0.254 mm (0.0015 -0.010 in.) and a piece of square, hard material 3 x 10 x 25 mm (1/8 in. x 3/8 in. x 1 in.), measure the flat on the injector rise side of the camshaft lobes and nose of valve lobes.See Figure 1-392 .

Figure 1-392 Checking Camshaft Lobe Wear [b] If the flats measure greater than 0.076 mm (0.003 in.) in depth and there are no other camshaft defects, replace the camshaft. [c] Inspect the camshaft bearings for signs of excessive wear, scoring or pitting. [d] Replace camshaft bearings as necessary. NOTE: If one camshaft bearing needs to be replaced, replace both of the camshaft bearing shells. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-433