1.26 CAMSHAFT GEAR ASSEMBLY SERIES 60 EXHAUST GAS RECIRCULATION (EGR) MODEL [e] Check the camshaft bearing clearance using plastic gaging material under each upper shell. NOTE: Check camshaft bearing clearance with bearing shells, camshaft, bearing caps and rocker arm shafts (without rocker assemblies in place) installed, and cap bolts, studs and nuts tightened to specification. [f] Allowable clearance is 0.09 - 0.166 mm (0.0035 -0.0065 in.) or a maximum of 0.191 mm (0.0075 in.) with used parts. [g] Replace excessively worn or scored parts. [h] After completing the camshaft bearing clearance measurements, remove the rocker arm shafts, bearing caps, camshaft, and camshaft bearings.
Keep the caps and shells together for possible reuse. [i] Clean all of the plastic gaging material from the bearing shells and camshaft journals if used parts are to be reused. [j] Remove all of the Gasket Eliminator from both the cylinder head and camshaft caps. Refer to "Cleaning" in the "General Information" section at the beginning of this manual. [k] Coat the No. 1 and 7 bearing shell inserts with clean engine oil and install them to their respective locations in the cylinder head and camshaft caps. [l] Install the camshaft to its normal position in the bearing saddles. Install the No. 1 and 7 camshaft caps to the cylinder head. [m] Install the No.
1 and 7 camshaft cap outboard bolts and inboard studs and torque, using socket tool (J–44706) to the studs to 128–148 N·m (94–109 lb·ft). [n] Using a dial indicator with magnetic base, check the run-out of the camshaft at the No. 4 bearing journal. See Figure 1-393. Figure 1-393 Camshaft Run-out Measurement (Rev. 2005) All information subject to change without notice. 1-434 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION