Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL [o] If camshaft run-out exceeds 0.050 mm (0.002 in.), replace the camshaft. 1.26.4 Assembly of Camshaft Gear Assembly Install the camshaft gear to the camshaft as follows: To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 40 psi (276 kPa) air pressure. NOTE: If a new camshaft is being installed, steam clean it to remove the rust preventive and blow dry with compressed air. 1. Using a suitable press, support the camshaft securely on the press. The bottom of camshaft must be firmly secured to prevent any movement. 2.

Install the camshaft gear into the camshaft gear cover and lower it as a assembly onto the nose of the camshaft. 3. Align the key in the camshaft with the key way in the camshaft gear. 4. Gently press the gear all the way onto the camshaft until it bottoms and is fully seated on the camshaft. 1.26.5 Installation of Camshaft Bearings and Camshaft Gear Assembly Install the camshaft bearings and camshaft gear assembly as follows: NOTE: If new bearings are to be installed, the upper and lower shells MUST be replaced as a set. 1. Coat the lower camshaft bearing shells with clean engine lubricating oil, and install them to their original positions.

Note the position of oil holes and locating tangs. 2. Coat the lobes and journals of the camshaft with clean engine lubricating oil. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-435