1.26 CAMSHAFT GEAR ASSEMBLY SERIES 60 EXHAUST GAS RECIRCULATION (EGR) MODEL 9. Lower camshaft assembly into position on bearings and gear case. See Figure 1-398. NOTE: Insure that the seal on the rear of the camshaft gear cover does not catch on the edge of the cylinder head. 10. When the assembly is in position remove the guide studs, install and hand tighten the four camshaft gear cover bolts until the camshaft gear cover just contacts the gear case do not torque. 11. Remove the alignment tool, the timing hole in the back of the camshaft gear cover should be visible in the center of the hole in the gear. Reinstall the alignment tool to verify timing is correct.
If timing is correct proceed to step 12. NOTE: Verify alignment tool is installed correctly. Incorrect installation will result in gear not being in time and the procedure will need to be repeated. 1. Camshaft Gear Cover 2. Timing Hole Figure 1-399 Timing Verification (Rev. 2005) All information subject to change without notice. 1-440 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION