Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 7. Apply RTV sealant along split line on gear case. See Figure 1-398. 1. RTV Sealant 4. Lifting Tool J–46305 2. Seal 5. Camshaft 3. Camshaft Gear Cover Figure 1-398 Application of RTV Sealant along Split Line NOTE: Camshaft gear cover assembly must be installed promptly to avoid the setting of the RTV sealant . PERSONAL INJURY To avoid injury when removing or installing a heavy engine component, ensure the component is properly supported and securely attached to an adequate lifting device to prevent the component from falling. 8. Install two guide studs (J–46302) into gearcase to guide camshaft gear cover assembly onto gear case.

Using lifting tool (J–46305), place front lifting hook between the number two injector lobe and intake valve and the rear hook between number four injector lobe and intake valve. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-439