SERIES 60 SERVICE MANUAL 12. Using the 3/4 in. square hole in the center of the crankshaft pulley, bar the engine over slightly so that the bolt holes in the holding tool align with the access cover bolt holes in the gear case cover. 13. Install the camshaft drive gear torque retaining tool (J–35652–B) to the gear case, engaging one of the lightening holes in the camshaft drive gear. Use two of the access cover bolts to secure the tool to the gear case cover. 14. Using a long 3/4 in. drive breaker bar and a 27 mm impact socket, remove the camshaft drive gear mounting bolt. Discard the bolt. 15. Remove camshaft drive gear torque retaining tool (J–35652–B) from the gear case cover. 16.
Insert a clean shop towel into the gear case opening to prevent removed bolts from falling into the gear case. NOTICE: Do not allow bolts or the shop towel to fall into the gear case. Failure to remove loose bolts or the shop towel from the gear case may result in severe gear train damage at engine startup. 17. Remove the three (current) or two (former) camshaft thrust plate mounting bolts carefully to avoid dropping them into the gear case. Refer to section 1.28.2. 18. Reverse camshaft gear pilot tool (J–35906) by turning it 180 degrees and install it to the camshaft drive gear access opening using three of the access cover bolt holes.
The J tool number should face away from the engine and the hub end of the tool should be inside the access hole. Tighten the three tool retaining bolts. 19. Engage the puller bolt in the threads of the camshaft drive gear hub until the bolt is tight. Turn the bolt clockwise, pulling the thrust plate towards the front of the engine approximately 6-7 mm (1/4 in.) until the camshaft hub contacts the J tool and the perimeter seal is clearly accessible. The gap between the end of the camshaft and the thrust plate should be wide enough to permit the perimeter seal to pass through. All information subject to change without notice. (Rev.
2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-449