Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.27 THRUST PLATE PERIMETER SEAL 20. Remove the number 1 camshaft bearing cap using socket tool (J–44706). See Figure 1-409. Figure 1-409 Removal of Camshaft Cap Stud 21. Using a flat-bladed screwdriver on the side of one of the camshaft lobes, lever the camshaft back and away from the thrust plate. 22. Using a hook-end pick (J–39227), reach into the thrust plate bore in the gear case, hook the perimeter seal, and pull it off of the thrust plate. Pass the seal between the thrust plate and camshaft and discard. Pull the diamond seal from the thrust plate groove and discard. 1.27.2.1 Inspection of Thrust Plate Perimeter Seal Groove Inspect the thrust plate perimeter seal groove as follows: 1.

Rotate the thrust plate by hand and visually inspect to make sure all seal material is completely out of the seal groove. If necessary, use a work light or flashlight to thoroughly inspect the groove. 2. Wipe the groove clean after inspection. 1.27.3 Installation of Thrust Plate Perimeter Seal Install the thrust plate perimeter seal as follows: (Rev. 2005) All information subject to change without notice. 1-450 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION