Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL NOTICE: Failure to install seals properly, failure to install new, dry (no lubrication) bolts where required, or failure to tighten bolts to the required torque using an accurately calibrated hand torque wrench may result in bolt loosening and loss of clamping load, which may cause severe engine damage. NOTICE: Do not use RTV or any other type of sealant on the thrust plate perimeter seal. Application of sealant will prevent proper seal crush (flow), which may result in seal leakage. 1.

After passing a new perimeter seal between the thrust plate and cylinder head, carefully install it in the thrust plate perimeter groove with the ribbed edges against the sides of the groove and the beveled edge facing out. NOTE: The former thrust plate perimeter seal was redesigned to provide greater reliability and less susceptibility to twisting during installation. See Figure 1-410 for design configuration. Figure 1-410 Thrust Plate Perimeter Seal All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-451