Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.27 THRUST PLATE PERIMETER SEAL NOTICE: Failure to properly seat the perimeter seal in the thrust plate groove will result in seal damage. If the seal twists at initial installation or when pushing in the thrust plate, the seal can be cut and damage will result. Any seal damage can result in seal leakage during engine operation. 2. Rotate the thrust plate by hand and feel the seal to ensure it is fully seated in the thrust plate perimeter groove. If any ribs are felt on the outside edge, the seal is twisted and must be adjusted. Apply Super Lube® to the inside bore of the gear case housing and not the seal. NOTE:

When pushing the thrust plate and seal into the gear case, the seal may appear to twist. Do not be concerned because it is only rolling a little. As long as the seal was not twisted when initially installed, the seal will straighten itself out because its profile is designed to resist rolling. NOTE: The former two-bolt thrust plate face seal was redesigned to provide superior oil sealing characteristics. See Figure 1-411 for design configuration. Figure 1-411 Two-bolt Camshaft Thrust Plate Face Seal NOTE: The current thrust plate uses a three-bolt design, as of serial number 6R352129. 3. Inspect the thrust plate face seal groove to ensure all seal material is removed.

Clean the face seal groove with LPS Contact Cleaner or equivalent residue-free cleaner. Do not use mineral spirits, since this will leave a residue. Wipe and dry the area thoroughly with clean paper towels. (Rev. 2005) All information subject to change without notice. 1-452 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION