Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. EYE INJURY NOTICE: Always bow out the cam cap bolt holes in the cylinder head before applying sealant and installing the cam cap. Failure to observe this step may cause lubricating oil trapped in the holes to push the sealant away from the cap when bolts are installed, resulting in a leak path. 4. For proper adhesion of the sealant at the cam cap/cylinder head joints, this area must be completely cleaned and all residue removed before new sealant is applied.

Clean the cylinder head and bearing cap contact surfaces thoroughly with LPS Contact Cleaner or equivalent residue-free cleaner. Wipe dry with clean paper towels. NOTICE: Failure to clean surfaces completely and remove all residue may result in improper gasket eliminator application, which may cause oil seepage during engine operation. NOTICE: Do not use RTV or any other type of sealant or spray adhesive on the camshaft diamond seal. Application of sealant or adhesive will prevent proper seal crush (flow), which may result in seal leakage. NOTE: Camshaft thrust plate face seals are not reusable.

When replacement of a perimeter seal or removal of the camshaft is required, a new camshaft thrust plate face seal must be installed. 5. Install a new seal in the thrust plate, making sure it is securely seated in the thrust plate face seal groove. 6. For engines built after May 1999, use sealant 23525918 (50 mL) or 23525919 (330 mL) in the two diagonal groove cuts of the front bearing cap only. For engines built prior to May 1999, apply DDC gasket eliminator 23523064, or equivalent, to the joint surfaces of the number 1 camshaft bearing cap. See Figure 1-412. To help ensure proper adhesion of All information subject to change without notice. (Rev.

2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-453