Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 9. Rotate the crankshaft, using the square hole in the middle of the crankshaft pulley, to align the lightening holes in the camshaft drive gear to the camshaft thrust plate mounting bolts. 10. Remove the camshaft thrust plate mounting bolts carefully, to avoid dropping them into the gear case. The current plate uses three bolts, the former plate requires two bolts. See Figure 1-425. NOTE: A clean shop towel may be inserted into the gear case opening to trap the bolts in case they are dropped. Do not allow the shop towel to drop into the gear case. 1. Camshaft Thrust Plate Mounting Bolt Locations Figure 1-425 Camshaft Thrust Plate Mounting Bolt Locations 11.

Install pilot tool (J–35906) to the camshaft drive gear access opening using three of the access cover bolt holes. Engage the puller screw in the threads of the camshaft drive gear hub, until the screw is tight. See Figure 1-426. Figure 1-426 Camshaft Thrust Plate Remover All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-469