Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.28 CAMSHAFT AND CAMSHAFT BEARING 12. Continue turning the puller screw to pull the camshaft drive gear hub and thrust plate forward approximately 6-7 mm (1/4 in.) until the thrust plate seal is clear of the camshaft front bearing cap and cylinder head. See Figure 1-427. Figure 1-427 Camshaft Thrust Plate Clearance 13. Remove the three bolts that secure the rear camshaft cover to the engine and remove the cover. 14. Remove the remaining seven camshaft cap bolts. Remove the No. 1 and 7 studs using socket tool (J–44706). See Figure 1-428. Figure 1-428 Camshaft Cap Stud Removal 15. Remove the seven camshaft bearing caps and the upper bearing shells.

Keep the caps and shells together for possible later installation. Tag the bearing cap location, as they must always be installed in the same location. (Rev. 2005) All information subject to change without notice. 1-470 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION