1.28 CAMSHAFT AND CAMSHAFT BEARING 1.28.3 Disassembly of Camshaft and Camshaft Bearing Refer to section 1.29.2 for disassembly of camshaft drive gear, camshaft hub and thrust plate assembly. NOTE: Disassembly of camshaft and drive gear assembly is not required for inspection. Disassembly will require timing of the camshaft gear again. For Series 60 engines equipped with Compact Gear Train Assembly disassemble camshaft from the camshaft gear as follows. 1. Use suitable fixture to secure the camshaft assembly from movement. 2. Install a heavy duty gear puller capable of withstanding the 48260 kPa (7000 psi) required to remove the gear from the camshaft.
Support the backside of the camshaft gear cover as close to the camshaft as possible to prevent damaging the gear cover and gently press the camshaft off the gear holding the camshaft as it is pressed through the gear. Removing the camshaft gear and cover together. NOTICE Extreme care must be taken not to support the camshaft gear cover at the outer edges. 1.28.3.1 Inspection of Camshaft and Camshaft Bearing Inspect camshaft and camshaft bearings as follows: 1. Clean all of the removed parts in clean fuel oil. 2. Ensure all oil passages are clear.
EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 3. Dry with compressed air. 4. Inspect the rocker arm components for scoring. Refer to section 1.3.2.2. 5. Replace damaged rocker arm components. (Rev. 2005) All information subject to change without notice. 1-472 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION