SERIES 60 SERVICE MANUAL 1.28.4 Assembly of Camshaft and Camshaft Bearing Refer to section 1.29.3 for assembly of camshaft drive gear, camshaft hub and thrust plate assembly. 1.28.5 Installation of Camshaft and Camshaft Bearing Install the camshaft and camshaft bearings as follows: 1. Coat the lower camshaft bearing shells with clean engine lubricating oil, and install them to their original positions. Note the position of oil holes and locating tangs. NOTE: If new bearings are to be installed, the upper and lower shells MUST be replaced as a set.
EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 2. When installing a new camshaft, steam clean it to remove the rust preventive and blow dry with compressed air. 3. Before installing the camshaft dowel into the camshaft hub, ensure that the dimple in the thrust plate is located at the 12 o'clock position to properly position bolt holes to cam cap and cylinder head. See Figure 1-433. Figure 1-433 Indexing Camshaft Dowel All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-477