Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.28 CAMSHAFT AND CAMSHAFT BEARING 4. Coat the lobes and journals of the camshaft with clean engine lubricating oil. Index the dowel pin in the camshaft with the dowel hole in the camshaft hub. 5. Lower the camshaft into position and slide the camshaft forward, making certain that the camshaft dowel indexes with its mating hole in the camshaft thrust plate hub. 6. Install the upper bearing shells to the No. 1, 4 and 7 camshaft caps, noting the position of the oil holes and locating tangs. NOTICE: Do not apply oil to the number 1 or number 7 camshaft bearing shells. These shells must be clean and dry for proper sealant application.

Applying oil to the number 1 or number 7 shells may result in oil leakage from the camshaft bearing caps. NOTE: The camshaft will still have adequate clearance from the number 1 and number 7 shells due to the oil film thickness on bearings 2 through 6. 7. Coat the number 2 through number 6 bearing shells with clean engine lubricating oil. 8. For engines built after May 1999, a race track seal is used on the Number 1 bearing cap. For bearing cap Number 7, use one rubber O-ring in the counterbore in the cylinder head. Before assembling the camshaft cap to the cylinder head, ensure the O-ring is in place on the cylinder head. 9.

For engines built prior to May 1999, install the two rubber O-rings to the counterbores in the cylinder head at the Number 1 and 7 camshaft cap locations. Before assembling the camshaft caps to the cylinder head, ensure the two O-rings are in place on the cylinder head. NOTICE: For proper adhesion, assemble parts while RTV is wet. So not allow RTV to form a skin. Gasket Eliminator must be kept from the bearing shell sets and bearing surfaces. Gasket Eliminator cures with the absence of air.

The length of time between installation of the Number 1 and 7 camshaft caps, and torquing the camshaft cap bolts and nuts should be kept to a minimum or improper lubrication will result causing engine damage. 10. Clean and dry the camshaft bearing cap joint face surfaces as well as the portions of the cylinder head face that mate with. These areas must be clean and dry for proper sealant adhesion. Use LPS®, Permatex®, or an equivalent non-filming degreaser. (Rev. 2005) All information subject to change without notice. 1-478 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION