SERIES 60 SERVICE MANUAL 11. Apply a continuous 1.6 mm (1/16 in.) bead of DDC gasket eliminator part number 23523064, or equivalent, to the joint face surfaces of the No. 1 and 7 camshaft caps. The bead must extend to the front edge of both caps. See Figure 1-434. Figure 1-434 Gasket Eliminator Application 12. Install the No. 1, 4 and 7 camshaft caps, with bearing shells in place, to their respective locations. 13. Install and tighten the two inboard studs and outboard bolts on bearing caps No. 1 and 7 using socket tool (J–44706), torque to 126–146 N·m (93–108 lb·ft). 14. Install the No. 4 bearing cap outboard bolt and torque it to 126-146 N·m (93-108 lb·ft). 15.
Remove the three bolts holding the camshaft gear pilot tool(J–35906) to the gear case. Remove the camshaft gear pilot. 16. Working through the camshaft drive gear access hole in the front of the gear case, tap the center of the camshaft drive gear with a fiber mallet or plastic hammer to move the camshaft thrust plate, hub and camshaft drive gear rearward in the gear case until the camshaft thrust plate bolts can be started in the cylinder head and No. 1 camshaft cap. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-479