1.28 CAMSHAFT AND CAMSHAFT BEARING NOTICE: Use care to ensure that the camshaft dowel is not disengaged during this step or damage to engine may result. NOTICE: Use care to prevent dropping thrust plate mounting bolts into the gear case. If not removed, fasteners dropped into the gear case may cause severe engine damage during start-up. 17. Install the thrust plate mounting bolts through the thrust plate and into the cylinder head and No. 1 camshaft cap. Using a 13 mm socket and ratchet, tighten the bolts alternately and progressively to draw the thrust plate straight into the gear case. Torque the bolts to 30-38 N·m (22-28 lb·ft). 18.
Coat the threads and underside of the head of the camshaft drive gear-to-camshaft bolt with International Compound #2 (or equivalent). Install the bolt to the camshaft, finger-tighten. NOTE: The camshaft should be held in place while starting the camshaft drive gear-to-camshaft bolt, to prevent disengaging the camshaft dowel from the thrust plate hub and requiring disassembly and timing of camshaft. NOTICE: Only retaining tool (J–35652–B) should be used to hold the camshaft drive gear stationary while loosening or tightening the camshaft drive gear-to-camshaft bolt to prevent component damage. 19. Insert retaining tool (J–35652–B)through a lightening hole of the camshaft drive gear. 20.
Bar the engine over slightly to position the camshaft drive gear holding tool so that the bolt holes in the holding tool align with the access cover bolt holes in the gear case cover using the 3/4 in. square hole in the center of the crankshaft pulley to bar the engine over. 21. Install two of the access cover bolts to secure the tool to the gear case. 22. Torque bolt to 75 N·m (55 lb·ft). (Rev. 2005) All information subject to change without notice. 1-480 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION