SERIES 60 SERVICE MANUAL 23. Turn bolt an additional 120 degrees. See Figure 1-435. Figure 1-435 Torque Turn Limits 24. Remove the camshaft drive gear torque retaining tool (J–35652–B). 25. Adjust the camshaft drive gear-to-adjustable idler gear lash. Refer to section 1.24.2.1. NOTE: Correct camshaft drive gear lash adjustment depends on the bolt and stud for No. 1 and 7 camshaft caps, the outboard bolt on No. 4 camshaft cap, and the camshaft drive gear-to-camshaft retaining bolt being tightened to the specified torque. However, the valve and injector spring pressures will not allow correct camshaft rotation.
Therefore, do NOT install the rocker arm shaft assemblies before the camshaft gear lash has been measured and adjusted. 1.28.5.1 Test of Camshaft End Play Measure the camshaft end play, using a dial indicator and magnetic base, as follows: All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-481