Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 1.28.6.1 Testing of Camshaft Timing for Diesel Engines Check the camshaft timing as follows: NOTICE: The camshaft must be in time with the crankshaft. An engine which is "out of time" may result in pre-ignition, uneven running or a loss of power. 1. Remove the valve cover. Refer to section 1.6.2 for one-piece rocker cover. Refer to section 1.6.3 for two-piece rocker cover. Refer to section 1.6.5 for three-piece rocker cover. 2. Select any cylinder for the timing check. 3. Remove the rocker arm assembly for the cylinder selected. Refer to section 1.3.2. 4. Remove the injector for that cylinder. Refer to section 2.3.2. 5.

Carefully slide a rod, approximately 304.8 mm (12 in.) long, through the injector tube hole until the end of the rod rests on top of the piston. 6. Using the 3/4 in. square drive hole in the center of the crankshaft pulley and a 3/4 in. drive breaker bar, turn the crankshaft slowly in the direction of engine rotation. See Figure 1-439. Stop when the rod reaches the end of its upward travel. Figure 1-439 Barring Engine Over NOTE: The cylinder selected must be on the compression stroke when performing this check. 7. Remove the rod and turn the crankshaft, opposite the direction of rotation, between 1/16 and 1/8 of a turn. 8.

Select a dial indicator with 0.0254 mm (0.001 in.) graduations and a spindle movement of at least 25.4 mm (1 in.). Provide an extension for the indicator spindle. The extension must be long enough to contact the piston just before it reaches the end of its upward stroke. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-485