Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.28 CAMSHAFT AND CAMSHAFT BEARING 9. Install a magnetic dial indicator base in a suitable place on the cylinder head and position the dial indicator over the injector hole tube. 10. Attach a suitable pointer to the gear case cover. The outer end of the pointer should extend over the vibration damper. 11. Turn the crankshaft slowly in the direction of engine rotation until the indicator hand just stops moving. Continue turning the crankshaft until the indicator hand starts to move again. 12. Reset the dial to zero. 13. Turn the crankshaft until the indicator reading is 0.254 mm (0.010 in.). 14. Scribe a line on the vibration damper in line with the end of the pointer. 15.

Slowly turn the crankshaft opposite the direction of engine rotation until the indicator hand just stops moving. Continue turning the crankshaft until the indicator hand starts to move again. 16. Reset the dial to zero. Then turn the crankshaft in the same direction until the indicator reading is 0.254 mm (0.010 in.). 17. Scribe a second line on the vibration damper in line with the end of the pointer. 18. Scribe a third line half way between the first two lines. This is top dead center for the cylinder selected when the pointer is lined up with it. 19. Remove the dial indicator and base from the engine. 20. Install the injector that was removed. Refer to section 2.3.5. 21.

Install the rocker arm assemblies. Refer to section 1.3.3. 22. Turn the crankshaft opposite the direction of engine rotation while watching the injector rocker arm cam follower for the cylinder selected. Turn the crankshaft until the cam follower is on the base circle of the injector lobe of the cam. 23. Install a magnetic dial indicator base on the cylinder head. Install a dial indicator so that the spindle rests directly on the injector cam follower roller for the cylinder selected. NOTE: The spindle should be on the center line of the injector cam follower roller pin in order to get an accurate measurement of cam lift. 24.

Turn the crankshaft slowly, in the direction of engine rotation, until the center mark on the vibration damper lines up with the pointer. (Rev. 2005) All information subject to change without notice. 1-486 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION