Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.28 CAMSHAFT AND CAMSHAFT BEARING 2. Select any cylinder for the timing check. 3. Remove the rocker arm assembly for the cylinder selected. Refer to section 1.3.2. 4. Remove the spark plug for that cylinder. 5. Carefully slide a rod, approximately 304.8 mm (12 in.) long, through the spark plug hole until the end of the rod rests on top of the piston. 6. Using the 3/4 in. square drive hole in the center of the crankshaft pulley and a 3/4 in. drive breaker bar, turn the crankshaft slowly in the direction of engine rotation. See Figure 1-440. Stop when the rod reaches the end of its upward travel. Figure 1-440 Barring Engine Over NOTE:

The cylinder selected must be on the compression stroke when performing this check. 7. Remove the rod and turn the crankshaft, opposite the direction of rotation, between 1/16 and 1/8 of a turn. 8. Select a dial indicator with 0.0254 mm (0.001 in.) graduations and a spindle movement of at least 25.4 mm (1 in.). Provide an extension for the indicator spindle. The extension must be long enough to contact the piston just before it reaches the end of its upward stroke. 9. Install a magnetic dial indicator base in a suitable place on the cylinder head and position the dial indicator over the spark plug hole. 10. Attach a suitable pointer to the gear case cover.

The outer end of the pointer should extend over the vibration damper. 11. Turn the crankshaft slowly in the direction of engine rotation until the indicator hand just stops moving. Continue turning the crankshaft until the indicator hand starts to move again. 12. Reset the dial to zero. 13. Turn the crankshaft until the indicator reading is 0.254 mm (0.010 in.). (Rev. 2005) All information subject to change without notice. 1-488 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION