Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 14. Scribe a line on the vibration damper in line with the end of the pointer. 15. Slowly turn the crankshaft opposite the direction of engine rotation until the indicator hand just stops moving. Continue turning the crankshaft until the indicator hand starts to move again. 16. Reset the dial to zero. Then turn the crankshaft in the same direction until the indicator reading is 0.254 mm (0.010 in.). 17. Scribe a second line on the vibration damper in line with the end of the pointer. 18. Scribe a third line half way between the first two lines. This is top dead center for the cylinder selected when the pointer is lined up with it. 19.

Remove the dial indicator and base from the engine. 20. Install the spark plug that was removed. 21. Install the rocker arm assemblies. Refer to section 1.3.3. 22. Turn the crankshaft opposite the direction of engine rotation while watching the intake rocker arm cam follower for the cylinder selected. Turn the crankshaft until the cam follower is on the base circle of that intake lobe of the cam. 23. Install a magnetic dial indicator base on the cylinder head. Install a dial indicator so that the spindle rests directly on the intake cam follower roller for the cylinder selected. NOTE:

The spindle should be on the center line of the intake cam follower roller pin in order to get an accurate measurement of cam lift. 24. Turn the crankshaft slowly, in the direction of engine rotation, until the center mark on the vibration damper lines up with the pointer. 25. Check the dial indicator reading: [a] The dial indicator reading for gas engines is 6.47 mm-7.54 mm (0.255 in. -0.297 in.). 26. If the camshaft lift is incorrect, re-time the engine. Refer to section 1.24.2.1. 27. Refer to section 12.7 for verification of proper camshaft and camshaft bearing installation. All information subject to change without notice. (Rev.

2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-489