Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.29 CAMSHAFT DRIVE GEAR 1.29.2 Removal of Camshaft Drive Gear Remove the camshaft drive gear as follows: 1. Remove the engine valve rocker cover. Refer to section 1.6.2 for one-piece rocker cover. Refer to section 1.6.3for two-piece rocker cover. Refer to section 1.6.5 for three-piece rocker cover. 2. Remove the camshaft drive gear access cover, fan bracket, (refer to section 4.6.3) and camshaft retaining bolt, refer to section 1.28.2. NOTICE: Use care when removing the camshaft thrust plate retaining bolts to prevent their accidental dropping into the gear case and causing engine damage. 3.

Working through the access holes in the camshaft drive gear, remove the three (current) or two (former) bolts that retain the camshaft thrust plate to the cylinder head and No. 1 camshaft bearing cap. See Figure 1-445. 1. Camshaft Thrust Plate Mounting Bolt Locations Figure 1-445 Camshaft Thrust Plate Mounting Bolt Locations (Rev. 2005) All information subject to change without notice. 1-494 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION