SERIES 60 SERVICE MANUAL 4. Pull the cam gear thrust plate assembly forward as far as possible to separate the assembly from the camshaft using J–35906. 5. Remove the gear case cover. Refer to section 1.10.2. 6. Using a fiber mallet or plastic hammer, tap the rear face of the camshaft thrust plate forward until it is free of the gear case. 7. Remove the camshaft thrust plate, hub, and camshaft drive gear as an assembly. See Figure 1-446. Figure 1-446 Camshaft Thrust Plate Assembly 8. Support the camshaft drive gear, with thrust plate facing down, on blocks. 9. Press the hub out of the camshaft drive gear until the hub separates from the camshaft thrust plate. See Figure 1-447.
Figure 1-447 Camshaft Hub Removal All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-495