SERIES 60 SERVICE MANUAL 1.29.2.1 Inspection of Camshaft Drive Gear Inspect camshaft drive gear as follows: 1. Clean all parts with fuel oil. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 2. Dry them with compressed air. 3. Examine the camshaft drive gear teeth for scoring, pitting, excessive wear and cracking, peening of the Woodruff Key slot. If damage is found, replace as required. 4. Visually examine the camshaft drive gear hub for scoring, pitting, galling or cracking. If damaged, replace drive gear hub. All information subject to change without notice.
(Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-497