Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 9. Install retaining tool(J–35652–B) and tighten the camshaft drive gear retaining bolt as follows: NOTICE: Failure to tighten the camshaft hub retaining bolt to the required torque may result in bolt loosening during engine operation, which may lead to camshaft alignment pin damage, altered engine timing, and erratic engine operation. [a] Apply a small amount of International Compound #2®, or equivalent, to the bolt threads and underside of the bolt head. [b] Install the bolt through the hub and thread into the camshaft. [c] Torque bolt to 75 N·m (55 lb·ft). [d] Turn the bolt an additional 120 degrees. See Figure 1-449.

Figure 1-449 Torque Turn Limits All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-501